What is a good acceptance rate for a journal?

What Our Research Shows. We looked at over 2,300 journals (more than 80% of them published by Elsevier), and calculated that the average acceptance rate was 32%. The range of acceptance was from just over 1% to 93.2%.

What is the acceptance rate for IEEE journals?

IEEE Access has an average acceptance rate of 30%, which is comparable to traditional IEEE journals. IEEE Access strives to uphold a high-quality, rigorous peer review process above all else.

What is the rejection rate of journals?

A 20% of the journals currently being edited receive 80% of the jobs, a figure that increases in Social Sciences where the journals present in the most prestigious international databases (JCR or Scopus) are less. This fact leads to high rejection rates, reaching, in some cases, an index of around 90-95%.

What is the acceptance rate for peer review journals?

The overall global average is around 35-40%. There are significant differences between fields of science, with biomedicine having higher acceptance rates compared to for instance the social sciences.

What is the acceptance rate of articles?

Acceptance rate (or rejection rate) is the ratio of the number of articles submitted to the number of articles published. It can measure the selectivity or prestige of a journal, though like many journal metrics, the raw number is not the whole story. There is no single list or database of acceptance rates.

9 Fast Publishing Free SCOPUS/SCI Journals II 10-100 % Acceptance Rate II My Research Support

What is the acceptance rate for PNAS?

The acceptance rate is currently 14%. A member or guest editor will typically secure two independent peer reviews. However, a single negative review, with which the editor agrees, may be sufficient to recommend rejection.

What is an acceptable rejection rate?

As long as the rejection rate is below 1%, it is normal. You can calculate the rejection rate as follows: Rejection rate = (expired number + repetition number + other) / (received number + expired number + repetition number + other) If the rejection rate is higher than 1%, it is recommended: 1.

Which journal rejects all submissions?

Journal of Universal Rejection. The founding principle of the Journal of Universal Rejection (JofUR) is rejection. Universal rejection. That is to say, all submissions, regardless of quality, will be rejected.

Can a journal reject after acceptance?

Chances are less , but sometimes your paper can can be rejected after receiving acceptance because in most of the journals they will simply send you the acceptance letter and when it's time to upload the paper on the journal they check few factors like , firstly your plagiarism level depending on the journals some ...

What is a good impact factor?

You can find a journal's impact factor by referring to the Journal Citations Report (JCR) or Scopus. 🍋 What is an average 'good' impact factor? In general, an impact factor of 10 or higher is considered remarkable, while 3 is good, and the average score is less than 1.

How hard is it to publish in IEEE?

IEEE Access has a typical acceptance rate of about 30%, which is comparable to other IEEE journals. Learn more about rapid peer review. Detailed below are the stages of peer review after article submission.

What is the acceptance rate for economics journals?

Currently, the QJE is the most selective of the top-five journals, with an acceptance rate of around 3 percent, followed by the JPE and RES, with acceptance rates of around 5 percent. The least selective of the top-five are AER and ECA, with acceptance rates of around 8 percent.

Is a 70% acceptance rate hard?

70% getting in is a good chance. Compare your stats to the average of the school, and decide where it lies on your likelihood spectrum. You could be the 1% or the 99%, and that matters a whole lot in this process.

What is a 100 percent acceptance rate journal?

Answer: Having a 100% acceptance rate would mean that all the papers that are submitted to the journal are accepted. This is rather unusual, but it might be possible if the journal accepts articles by invitation only.

Who has the hardest acceptance rate?

Niche, a ranking and review site, recently published its list of the “2023 Hardest Colleges to Get Into.” Using data from the U.S. Department of Education on various colleges' acceptance rates and SAT/ACT scores, they found, unsurprisingly, Harvard University to be the most difficult college to get into.

Is it bad to keep publishing in the same journal?

There's no question that publishing in a single journal can have a major impact on your reputation as an academic. After all, if you're publishing in the same journal over and over again, people are going to start to notice.

Can I resubmit to the same journal after rejection?

This depends on the type and severity of the rejection, as well as the scope and quality of your work. If the rejection was based on minor or moderate issues that can be fixed easily, you may consider resubmitting to the same journal, especially if it is a high-impact or prestigious one.

Why does my manuscript keep getting rejected?

Here are some possible reasons: Poor writing: If the writing is of poor quality, with grammar and spelling errors, unclear sentences, or weak storytelling, the editor may reject the manuscript outright. Lack of originality: If the story is not original or has been done before, the editor may pass on it.

What does a high rejection rate mean?

The rejection rate is a performance-oriented recruiting indicator that shows how high the percentage of applicants in a recruitment process is who are classified as “not suitable” by the company and are thus rejected. The value is given as a percentage.

What is rate of false rejection?

The false reject rate (FRR) measures how well your system can identify legitimate users. It is the percentage of times that a user is incorrectly rejected by your system. The false accept rate (FAR) measures how well your system can identify imposters.

What is a good defect rate?

Some profitable products have very high defect rates (over 20%), but are still financially beneficial. Other products exist on the thinnest margins- a defect rate of . 3% or less is what is needed to be profitable.

Is PNAS hard to publish?

Depends on what you call as level. Its impact factor is less than that of Science but nonetheless it is highly competitive. Publishing in PNAS is not an easy job even if you think your work is good enough. In general Science publishes strikingly novel work while Nature usually publishes extensive work.

Is PNAS a top tier journal?

Nature, Science, and PNAS are the three most prestigious general-science journals, and Nature and Science are among the most influential journals overall, based on the journal Impact Factor (IF).